Color Seal II™

Tinted water-base semi-transparent curing compound and sealer for Colored Concrete

Description

Color Seal II™ is a membrane forming acrylic co-polymer sealer which is sprayed-on fresh colored concrete as a curing compound. It is used instead of water curing or plastic curing sheets which can discolor the slab. Color Seal II™ Keeps water in the slab while it cures which helps prevent cracking and optimizes final hardness. It also dust proofs and seals the surface to protect against water damage and most stains. It is semi-transparent and tinted in 40 different shades to match our color card for integrally colored concrete.

USE: NEW COLORED CONCRETE:
Applied as a curing compound to prevent rapid evaporation and promote proper slab hydration for strength and hardness. When applied in very thin coat, also used to hide minor surface discoloration. Second and third coats are used to completely hide or paint over the concrete. Common concrete applications are for decorative residential and commercial concrete such as driveways, patios, walkways and cart paths in both interior and exterior applications.

OLDER COLORED CONCRETE:
Color Seal II™ is applied in light coats over existing colored concrete to renew the color appearance and seal and protect against moisture damage and most stains.

LIMITATION:
Color Seal II™ does not color uncolored concrete. When used to paint over stains or discoloration, can appear glossy, unnatural or be susceptible to tire marks. Color Seal II™ will wear sooner when used on warehouse floors, floors subject to chemical or acid exposure, steel wheel or fork lift traffic or high degree of abrasion. When wet, sealed surfaces will be more slippery than unsealed surfaces, Final sealer color is matched to our printed color card. Actual color of unsealed concrete may differ from sealer. Do not use on exposed aggregate finishes. Do not use on sections which will receive concrete overlays, toppings, coatings, joint sealants or on areas of poor drainage or as a membrane barrier against hydrostatic water pressures.

COMPOSITION:
Proprietary emulsion of modified acrylic co-polymer, water, long alcohol, pigment, surfactant.

PACKAGING:
Two gallon plastic pail. Shipping weight 18.5 pounds (8.4 kg). Minimum quantity for pallet shipment 32 gallons (16 pails). Weight including carton for parcel or overnight shipment 20.0 pounds (9.1 kg) each.

 

Surface Preparation

FRESH COLORED CONCRETE:
Apply after all bleed water and surface sheen has evaporated, finishing has been completed and concrete has achieved an initial set

HARDENED COLOR CONCRETE:
Clean surface or oil, grease, dust, dirt or foreign matter. Rinse with water.

OLD, DUSTY COLORED CONCRETE:
Clean surface or oil, grease, dust, dirt or foreign matter. Remove dusty surface with light-duty concrete cleaner or a solution of 1 part Muriatic (Hydrochloric) Acid diluted with 20 parts water. The flush completely with water.

Application

  • Protect Surrounding structures from overspray.
  • Choose Color Seal of the same color as the concrete.
  • Loosen pigment from bottom of pail with stirring tool and stir until color of liquid becomes homogeneous. Color of liquid will appear lighter than final shade when dry.
  • Apply when ambient and surface temperature is above 45° F (7° C) and expected to remain above fro at least 12 hours.
  • Apply to surfaces that are dry or damp but not wet.
  • Apply with new or clean airless or pump sprayer that is free from any resin, oil or solvent residue.
  • Use sparingly with sprayer on lightest mist setting for maximum atomization of spray. Ordinary pump canister sprayers for garden or construction use will NOT atomize spray adequately. Use canister spray designed for application of wood finishes or form release agents with the smallest available flat-fan spray tip (.10 to .30 GPM). A powered airless sprayer produces the best spray pattern.
  • Apply then coat, otherwise finished surface may appear "painted".
  • Fog lightly over sloped surfaces or impressions to prevent runs and streaks.
  • Do not allow sprayer to spit or sputter. Unclog nozzle and repressurize before continuing.
  • If clogging continues, empty sprayer back into pail. Clean and flush sprayer with hat water. Then pour sealer through fine strainer or cheesecloth when refilling.
  • If spray equipment is not available, a short knap paint roller can be used. However, a roller may leave streaks and overlap marks and will result in a "painted" appearance. For best results, use a powered airless sprayer.
  • DILUTING/THINNING: Clean water may be stirred in to make sealer more transparent. Gradually add water and test apply until sealer dries to desired transparency. When thinned, Color Seal II may form an incomplete seal and will not form and adequate curing membrane on fresh colored concrete. Thinning voids specifications and warranty.

Precaution

  • Test apply to small area. Let dry and approve color and finish before proceeding.
  • Over application will result in a thick coat that can look unnatural and could remain "tacky" When heated by sun light. Thick coats also show tire marks and tire "prints" more than thin coats.
  • Puddles or drips should be wiped up before they dry.
  • Do not apply if rain, dew or water exposure is expected within 24 hours after application.
  • Do not apply in dusty conditions. Dust and dirt will adhere to the product when wet and be locked into it as it dries.
  • Color Seal II™ will not adhere properly to waxy, painted or otherwise sealed surfaces. Other curing agents or waxes must be stripped completely before attempting to apply Color Seal II™.
  • DRY TIME: Color Seal II™ will skin over in 30 minutes and harden in approximately 4 hours. Allow 24 hours to dry completely. Weather conditions can retard or advance dry time from 1 to 8 hours. Dry takes longer when applied as a curing compound on fresh concrete. If a second coat is desired, allow the first coat to dry over night before re-application. Make certain the sealer is hard before resuming floor traffic. Allow at least 7 days before resuming automobile parking.

     

Coverage Rates

USE (Unthinned)

SQ.FT./GAL

Curing Compound on fresh concrete, First Coat:

250-300

Cure/Seal on hardened fresh concrete, Second Coat:

350-450

Seal and restore colored concrete,
First Coat:

300-400

Seal and restore colored concrete, Second Coat

400-500

CLEAN UP:
Use soap and water promptly after application, before sealer is allowed to dry.

MAINTENANCE:
Color Sealed surfaces can be kept clean by washing with soap and water. Abrasive cleaners, harsh chemicals, acids and some floor strippers can damage the sealer finish. So can normal wear and tear. Color Seal II™ may be reapplied to damaged or worn areas. Use a trigger spray bottle or paint brush for touch-ups.

Technical Data

  • Surpasses ASTM C309 requirements
  • Surpasses California AQMD rule 1113 requirements
  • V.O.C. content: 203 g/l
  • Solids content: 22%
  • Viscosity (centipoises): 3 @ 68° F (20° C)
  • Freezing point: 32° F (0° C)
  • Flash point: Non-Flammable
  • Weight/gallon: 8.7 lbs. (4 kg)
  • % Volatile: 78%
  • Shelf Life: 1 year

 

APPEARANCE:
Milky colored when liquid. Semi-gloss and Semi-transparent when dry. Will not yellow.

STORAGE:
Store away from heat sources. Do not allow to freeze which can cause permanent damage.

DISPOSAL:
Store excess sealer for touch ups. Take waste sealer to household hazmat round-ups or donate to civic or graffiti clean-up services. Do no pour down household or storm drain.

 

CAUTION: DO NOT TAKE INTERNALLY KEEP OUT OF REACH OF CHILDREN

LIMITED WARRANTY: Davis Colors™ warrants the original purchaser of this product against defects in materials for a period of 8 months from date of purchase. Notice of any claim of defect must be given in writing. Davis Colors™ will either provide replacement product or refund the purchase price for the amount of sealer found defective at our option.

THIS IS THE ENTIRE WARRANTY AND NO OTHER WARRANTY, WHETHER WRITTEN OR ORAL, IS EXPRESSED OR IMPLIED. Davis Colors™ SPECIFICALLY DISCLAIMS THE WARRANTIES OR MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE REMEDIES PROVIDED HEREIN ARE BUYER'S SOLE AND EXCLUSIVE REMEDIES. IN NO EVENT SHALL Davis Colors™ BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING LOSS OF PROFIT OR LABOR COSTS) WHETHER BASED ON CONTRACT, TORT OR ANY OTHER LEGAL DOCTRINE.

We welcome questions or comments.
Or call:   West: 800-356-4848   East: 800-638-4444